Samlex Europe WSC-1250, Manual

Page: 21 / 29

21
ENG
9 Using the Charger
9.1.5 Equalization
The function of equalization could be activated as long as the battery charger is NOT in the
half power mode or power supply mode.
The function of equalization will be activated only when the battery is charged and stays in
Uo phase with < 25% of Full load current.
The battery charger will charge the battery 3 hours with equalization setting voltage
(15.5V or Uo phase setting voltage) and half of rated current.
Note
Once the equalization function is activated, it can only be cancelled by turning off the battery charger.
9.2 Using the remote controller RC-600
There are three buttons and four LEDs on RC-600 (see Figure 10 Remote Controller RC-600,
Page. 6).
• ON/OFF button to switch the charger ON and OFF
• Half Power button to enter/exit "HALF POWER" mode
• Equalization button to activate the function of equalization
• Bulk LED to indicate the charging stage of I phase
• Absorption LED to indicate the charging stage of Uo phase
• Floating LED to indicate the charging stage of U phase
• Equalization LED to indicate the function of equalization is activated
To avoid the VOID setting from the remote control, please refer to Table 9-1 VOID Setting.
Table 9-1 VOID Setting table for pressing button on remote controller
RC-600 buttons
Charger working mode
Half power Equalization Others Power Supply
"HALF POWER"
pressed
Exit "HALF
POWER"
("STATUS" LED
lights)
VOID
Enter "HALF
POWER"
("STATUS" LED
flashing)
VOID
S3 "E.Q." pushed
VOID VOID
Equalization
("E.Q." LED
lights Red)
VOID
"ON/OFF" pressed
Stand by
("STATUS" LED
slowly flashing
Red)
Stand by
("STATUS" LED
slowly flashing
Red)
Stand by
("STATUS" LED
slowly flashing
Red)
Stand by
("STATUS" LED
slowly flashing
Red)