Samlex Europe WSC-1250, Manual, Page: 14 / 29

14
ENG
5 Accessories
5.1.2 Installation
• Lay the cables from the batteries to the charger.
• Connect the temperature sensor to the "TEMP" socket of the charger.
• Connect the temperature sensor to the negative pole of the battery, or use a double-sided
adhesive tape to attach the sensor to the top of the battery or in the vicinity of the battery
(see Figure 15 Temperature Sensor Setup, Page. 9)
Note
The length of TF-100 cable is 5M.
5.2 Remote Controller RC-600
Figure 10 Remote Controller RC-600, Page. 6.
5.2.1 Functions
• Switch the charger ON and OFF.
• Half power mode ON / OFF.
• Equalization ON.
• Status monitoring.
Note
Attach the remote control at a well accessible place to ensure easy access of the charger.
Be careful when attaching the remote control, for wiring harnesses, cables and other
components that are in the assembly range could be damaged in the process!
5.2.2 Installation
• Ensure approximately 49mm width, 49mm height and 23mm depth for the take-up of the
remote controller (see Figure 11 Remote Controller RC-600, Page. 7).
• Connect the remote control to the charger. The connection cable is equipped with two
equivalent modular plugs.
• Place the remote control into the opening created. Secure the remote control with screws
on the upper and bottom margin of the faceplate – use the available drills.
Note
The length of RC-600 cable is 10M.
Note
The power switch at the unit must be switched ON, so that the unit can be switched ON and OFF with
the remote control.