Samlex Europe WSC-1250, Manual

Page: 12 / 29

12
ENG
2 WARNING
Warning!
Please read carefully about the following precautions.
Damages caused by failure to follow the instructions below will NOT be covered by warranty.
• Use the charger only as intended.
• Do NOT operate the charger if the housing or the cables are damaged.
• The charger may NOT be used to charge any other type of batteries than the ones indicated.
• Do NOT operate the device in a damp or wet environment.
• Do NOT charge a frozen battery; there is the danger of explosion.
• Keep this charger in a safe place, out of reach of children.
• Only qualified personnel who are familiar with the risks involved and the relevant
regulations should carry out maintenance or repair work.
• The device must be fixed and installed in such a way that it will NOT fall over or fall down.
3 Applications and Descriptions
The chargers regenerate power or recharge mobile batteries used onboard vehicles or boats.
The charger can continuously charge supply batteries or starter batteries, enabling the
batteries to maintain at a high capacity level.
The charger can be used for charging three types of batteries:
• Gel / AGM batteries
• Lead-acid starter batteries
• Maintenance-free batteries
Please inquire your battery supplier about the maximum capacities of your lead-acid
batteries.
The charger is equipped with a polarity protection; this prevents the charger from being
damaged in case of incorrect polarity.
An optional temperature sensor, (Figure 9 Temperature Sensor TF-100, Page. 6) that is
connected at the battery being charged protects the battery against damage cause by
varying outside temperature by adapting the charging voltage of the temperature to the
battery. Please connect two ends of Figure 9 Temperature Sensor TF-100 on Page 6 –
one end to “TEMP” socket on front panel and another end to the battery.
An optional remote control (Figure 10 Remote Controller RC-600, Page. 6) can be obtained in
order to provide remote access to the charger.