18
ENG
8 Settings
8.2 Half power mode setting
When the switch S2 “HALF POWER” is pushed, the output power will reduce to half of the
chargers' amp rating and the “STATUS” LED will flash. The switch S2 is a kind of no memory
switch. That means "ON/OFF" status cannot be identified from the switch. To enter and exit
the "HALF POWER" mode by turns, please push the switch S2. The "HALF POWER" mode can
be told from flashing "STATUS" LED.
Due to the fan speed is adjusted according to the function of the load and the temperature
inside the charger, when "HALF POWER" mode is on, the fan speed will be slowed down and
become silent because of output current reducing to half the charger amp rating.
Note
1. The half power mode can be set only when equalization function is NOT activated or the charger is
NOT in the power supply mode. (see Table 8-5 VOID Setting table for pushing switch on front panel,
Page. 19)
2. Please refer to section 9.4 on page 23 to understand the function of fan speed.
8.3 Equalization setting
When the switch S3 “E.Q.” is pushed, the function of equalization is activated and the “E.Q.”
LED will light RED. Whenever the function of equalization is activated, it only can be cancelled
by turning off the charger.
Note
The equalization function can be set only when the charger is NOT in the half power mode and NOT in
the power supply mode. (See Table 8-5 VOID Setting table for pushing switch on front panel, Page. 19).
8.4 VOID setting table
To avoid the void setting, please refer to Table 8-5 VOID Setting table for pushing switch on
front panel, Page. 19.
Summary of Contents for WSC-1250
