
SAMIX
®
ES500
44
8
Fault causes/troubleshooting
8.1
Instructions in the event of faults
Fault
Troubleshooting
The SAMIX
®
ES500 cannot be
switched on.
Check whether there is supply voltage and the connector is correctly
connected to the socket.
The SAMIX
®
ES500 switched off
due to an overload.
Switch off the power switch.
Observe a cooling period of 30 minutes.
Tab. 5: Faults and troubleshooting
NOTICE
In the event of irregularities, a fault message is shown on the display. Information on the cause
of the fault and troubleshooting can be found in section „8.2 Fault messages“.
NOTICE
An incorrect assignment of the mixing blades to the jars can trigger fault messages.
After the device is switched off and the operating fault has been eliminated, the
SAMIX
®
ES500 works again normally.
Following troubleshooting perform a function check in accordance with the details
under "Function check or initial operation" in the enclosed document "Installation
Qualification (IQ)".
In the case of serious faults, note the device type and contact the manufacturer.
NOTICE
In the case of faults needing repair, send the entire SAMIX
®
ES500 device to SAMIX GmbH.
Use the material of the original packaging or request packaging material from SAMIX GmbH
when sending in the device.
NOTICE
After an operation period of approximately 500 hours, the contact carbon brushes of the
SAMIX
®
ES500 may be worn. The contact carbon brushes are replaced during the regular
maintenance work performed by SAMIX GmbH.
The inspection and maintenance work to be performed for documentation within the frame-
work of a QM system can be obtained from customer service upon request.