
25
SAMIX GmbH
Operation
6.3
Preparation of mixing process
Proceed as follows after weighing in the recipe components:
1. Gently screw the mixing blade and the jar lid on the jar housing.
2. Push the jar base upwards using your thumbs so that air escapes between the jar
lid and jar housing.
With this air reduction, any overpressure in the jar is released and the escaping of the
ointment at the sealing areas of the jar during the mixing process is prevented. The
mixing result is also optimized by avoiding air pockets.
NOTICE
If the air is not released from the jar, an air column forms on the inside when mixing the oint-
ment, meaning the mixing blade cannot clean itself. In this case, unmixed components may
remain adhered to the mixing blade.
3. Firmly screw down the mixing unit.
NOTICE
Screw the jar lid onto the jar. If the jar lid is screwed on at an angle, the mixing blade tilts upon
automatic entry into the bayonet guide.
NOTICE
When incorporating large powder amounts, it is recommended to repeat the air release after
approximately 15 seconds of mixing.