SAMES KREMLIN
Page 9
Manual : 573.005.212
MONTHLY CARE
Check the parameters of the REGULEX® bay (refer to bay instruction manual).
Check the wear of the friction ring at the lubrication level. Give the ring a quarter turn or change it
if necessary.
Lubricate the screw ball (every 300 hours).
(KLUBER grease - P.N°. NB 52)
(screw ball duration : 500 000 cycles)
HALF-YEARLY CARE
Remove the gun fluid part :
- Clean the valves, the fluid chamber. Change the valves, if necessary.
- Change the seals and the defective parts.
- Check the piston condition.
Define the offsets on the REGULEX® bay (refer to § 5 and to bay instruction manual).
YEARLY CARE
Check the electrovalves.
Check the screw ball.
Lubricate the outside and inside teeth of the reducer and of the bearings
(HARMONIC DRIVE grease - P.N°. SK1A)
7. TROUBLESHOOTINGS
If a problem occurs during the operating of the REGULEX®, the fault will be displayed on the display
unit (refer to bay instruction manual).
8. DISASSEMBLY- ASSEMBLY
Guards (air motor cover, coupling shields, housings …) have been designed for safe
use of the equipment.
The manufacturer will not be held responsible for bodily injury or failure and / or
damage to property due to removal or partial removal of the guards.
Before removing the REGULEX® proportioning gun :
-
Shut off the pump air supply (pump into service).
-
Drain the REGULEX®.
-
Open the pump drain cock.
-
Shut off the REGULEX®.
-
Disconnect all the electrical connection beads.
-
Put aside the REGULEX® proportioning gun.
