SAMES KREMLIN PU3000 2L 53/1, Translation From The Original Manual

Page: 38 / 135

SAMES KREMLIN Page 26 Manual : 573.199.112






PRODUCTION (F1)
If the machine is in mixed material, open the gun spraying air supply valve.
Trigger the gun.
Adjust the spraying air regulator to get the desired fan.
When passing to production for the first time, the machine carries out a
regeneration.
The display consists of a countdown that enables to know, in percentage (9

between 90% and
100% of the volume), the volume remaining to be dispensed according to the P3 parameter. At the end
of that stage, the machine enters in production. You can also activate
ESC during the fluid priming; we
advice you not to start painting inmediately.
In production, there are 3 main screen messages:
- The operator is spraying and the PU 3000 is operating correctly. The real mixing ratio is
displayed on the screen.
- The machine stops because of a malfunction. The kind of breakdown is displayed on the
screen, the machine emits an alarm signal to inform the operator (cf §
'TROUBLESHOOTINGS').
- The machine has reached the maximum life duration of the material and passes automatically
in regeneration mode. The machine emits an alarm signal to inform the operator. The following
screen is displayed :
Open the gun until the regeneration ends (shut off spraying air), then the machine passes to
production.
To exit from production : activate ESC .
Nota : We recomend to keep the nozle on the gun during the color priming / regeneration.
The CATALYST pressure must always be higher by 5 to 10% than the
BASE pressure.
If the machine is not in mixed material, a regeneration is automatically carried out
to bring the mixed material to the gun.
We advise you to shut off air during that stage.
You can stop the regeneration by activating ESC. Then, the regeneration will stop,
but be careful, the quality of the mixed material can be inferior.
Real mixing ratio


   
