SAMES KREMLIN
Page 22
Manual : 573.199.112
9. APPLICATION PROGRAMMING (F3)
To alter the parameters of the PU 3000, go to F3, then validate. To shift from a parameter to another,
use the arrows
or
.
Select the parameter to alter. Depress the key
OK
, then the arrows
or
to increase or
decrease the value. Activate
OK
to validate the new value or ESC to cancel.
To quit a parameter, activate
ESC
.
To quit the PARAMETERS menu, activate
ESC
.
The parameters are pre-set up in the factory. They must be adjusted (by an authorized person) to suit
the material to be processed.
The calibration of the stroke length is carried out in the factory. When removing the movement
sensors or when disassembling the fluid section from the motor, it is important to initialize the pumps
(refer to Validation of the initialization mode, page 25).
PASSWORD
When you start the machine for the first time the access code of the menu `Parameters' is
deactivated, everyone is able to modify the machine’s parameters.
To activate this access code you have to :
- enter in the parameter 0 of the menu F3 :
« key
»
« key
».
The code
‘
’
appears, it’s the code present by default in the machine.
- change the code by using the arrows
or
and the «key
» for each digit which compose
this code.
Once the access code was validated, the access is protected by the password. Only the people
who know this password and those which know the administrator code
‘
’
will be able to
reach the menu `Parameters'.
Each time a user wants to enter in the menu 'Parameters' the password will be required:
. The user shall enter the password by using the arrows
or
and the «key
» for
each digit which compose this code :
- If the entered code is correct, the following fonts
appear.
- If the entered code is incorrect, the word ‘
appears and the machine allows you to enter
the password again (Press 'Esc' to return to the principal menu).
If you want to desactivate the password, you just have to parameterise the code
‘
’
again
as access code.
PROCEDURE TO GET THE VERSION NUMBER OF THE ELECTRONIC CARD
- Switch off the unit.
- Input
OK
.
- Switch on the control box : the version number is displayed.
- Release
OK
to start the machine out.
Summary of Contents for PU3000 2L 53/1
Page 63: ...SAMES KREMLIN Page 51 Manual 573 199 112 SPECIFICATIONS PU 3000 PUMP model Airless...
Page 68: ...SAMES KREMLIN Page 56 Manual 573 199 112 SPECIFICATIONS PU 3000 PUMP model 4 L 30 1...
Page 73: ...SAMES KREMLIN Page 61 Manual 573 199 112 SPECIFICATIONS PU 3000 PUMP model 4 L 53 1...
Page 79: ...SAMES KREMLIN Page 67 Manual 573 199 112 SPECIFICATIONS PU 3000 PUMP model 4 L Flowmax 53 1...
