Doc.-ID: 181210-PT10BA-ES-RoughCam IPM3016_en_rev.00.docx, page 18 of 24
Attention!
Beware not to damage the surface of bore hole and shaft (fit).
Attention!
Please make sure not to damage housing sealings and to keep them
clean.
The two control buttons are located on the Axis modules main board (q.v. Figure 5.2); the
outer push button is used for carrying out the hardware reset.
Figure 5.2
– Location of the control button
In order to be able to press the control button, the black mounting adapter has to be dis-
connected from the stainless steel flange. To do so, please take off the M3*0.5 16 mm
cylinder head screws (DIN 912) with the associated washers (DIN 127 A) (q.v. figure 5.3)
Figure 5.3
– Disconnecting the mounting adapter
