Doc.-ID: 181210-PT10BA-ES-RoughCam IPM3016_en_rev.00.docx, page 17 of 24
5
Hardware Reset
A hardware reset should only be carried out under the following conditions: The camera
is not accessible in the network even though it has been disconnected from power, after
a failed firmware update, or a factory reset has been explicitly asked for. For carrying out
a hardware reset it is allowed to open the housing. All required steps are described in
chapters 5.1 to 5.3 of this user manual.
5.1
Work preparation
Attention!
Please carry out any preoperational work carefully and in accordance
with the applicable regulations.
Use appropriate tools
Make sure you have a secure foothold
Avoid static charge
5.2
Opening the housing
Opening the camera housing is only allowed to carry out the hardware reset of the M3016
camera module. The steps below have to be followed very carefully:
Figure 5.1
– Opening the RoughCam IPM3016
