20
"F"
"H"
"J"
"G"
"K"
"K"
Fig. 8.
Model in vertical -tower type- assembling with ex-
tended back up time (battery module).
Ŗ
Regarding the connections of the UPS with the battery
module in models up to 6 kVA, make the following steps, but
reading section 4.3.4 previously:
Connect the supplied earth joint cable "F", between the
UPS and battery module.
Remove the beautiful front cover of the equipment and
battery module, as it is described in section 4.2.5.2.
Take the extensible cable with connector "H" of the bat-
tery module and connect it with the "G" connector of the
equipment.
To connect it with other battery modules, there is the "J"
connector. Take the extensible cable with "H" connector
of the beside battery module and connect it to the "J" con-
nector of the previous one. Repeat the same steps for a
high quantity of modules.
In the side of each front cover, there are the "K" trims as
hole to go the cables through it with the battery modules.
Break the needed trims to pass the connection bus.
Put the beautiful front cover back of the equipment and
battery module, as it is stated in section 4.2.5.2.
Ŗ
For 8 and 10 kVA UPSs with the battery module, proceed as
follows, but reading section 4.3.4 previously (see figure 11):
Connect the supplied earth joint cable , between the UPS
and battery module.
To connect the battery module with the equipment, there
is a connector on the rear side of both units. Insert the
aerial connector from battery module into the connector
of the equipment.
Battery module has base connector, foreseen to connect
the aerial connector from another module .
4.2.5.5. 19" rack cabinet mounting.
Ŗ
All models can be installed in a 19" rack cabinet, attending
the height of each model:
Models up to 3 kVA, 2 units height.
Models from 4 and 6 kVA,3 units height.
Models of 8 and 10 kVA, 5 units height.
"A"
"C"
"B"
Fig. 9.
19" rack cabinet assembling.
USER MANUAL
