SAKI BF-Sirius, Manual

Page: 31 / 72

I- 25
BF-Sirius
Operation Manual
If inspection result is OK, the dialog shown in Figure 3-36 appears. Press Step3: OK and unload /
load the PCB. Push the start switch to start the next inspection.
In Case that Inspection Result is OK FFFure 3-3 6
If inspection result is NG, the dialog shown in Figure 3-37 appears.
Each item is described in Table 3-4 and 3-5.
NOTE It enables to start scanning next PCB while judging the result.
B A
C
D
Edit NG Component Data FFFure 3-3 7
(A) Upper Right Image Show the point that the result will be NG.
(B) Upper Left Image Show the position of upper right image using yellow lines.
By comparing these two images, (A) and (B) with the actual PCB, determine a good PCB
vs. a defective PCB, and whether the defect is a false or not.
OK Press if the PCB that result will be OK.
REPAIR Press if the PCB that result will be NG.