Sakai SV540 Series, Operating & Maintenance Instructions

Page: 50 / 108

2. OPERATION
– 44 – – 45 –
2.3.4 Traveling
CAUTION
While travelling, do not turn the starter switch " " position.
WARNING
• When starting, operate the horn after securing the safety around the machine.
• Be sure to wear the seatbelt during operation.
1) Select the desired speed by the speed change switch.
km / h (mile / h)
(Low) (High)
Speed 0 – 6 (0 – 3.7
）
0 – 10 (0 – 6.2
）
IMPORTANT
Be sure to shift gears while the machine is stopped. Can not shift gears during
running.
WARNING
On a steep slope, run the machine at low speed.
2) Turn the engine speed select switch to increase the
engine speed.
2. OPERATION
– 44 –
4) Turning the key to the " " position makes the engine
start. Release the key the moment the engine has
started. The key will automatically return to the " "
position.
CAUTION
• Do not allow the starter key to stay in the " " position for more than 15
seconds.
• When the engine fails to start, or you want to restart the engine immediately after
turning it off, wait around 30 seconds before restarting it.
• Check that the warning lamps on the monitor display go off immediately after
the engine is started. If any of these warning lamps stay on while the engine is
running, shut down the machine, determine the cause and rectify the fault.
2.3.3 After starting the engine
Try not to move the machine immediately after starting but practice the following:
IMPORTANT
Avoid increasing the engine speed abruptly before warming-up run is completed.
1) Run the engine at idling for about 5 minutes to warm it up. Warming-up run allows the
lubricating oil to reach the vital parts of the engine and hydraulic system, gradually warm
the engine, engine oil and hydraulic oil to prepare the machine for driving.
2) After the warm-up operation, check that:
• Temperature gauge .............................. Pointer falls near the center zone
• Fuel gauge ........................................... Pointer falls between the E and F marks
• Charge lamp......................................... Has gone off
• Engine oil pressure warning lamp ........ Has gone off
• Engine check lamp ............................... Has gone off
3) Check for the color of exhaust gas, listen for unusual sounds and vibration. If abnormal,
determine the cause and correct the problem.
WARNING
Stay in the driver seat during operation.