BarbLock® Tabletop Pneumatic Assembly Tool: Operations Manual
www.biopharm.saint-gobain.com
7
FLS-5278C-CLWR-Rev 01
5.0 Tool Controls and Features Continued
Latch – push on
opposite side to
open Safety Cover
Pinch hazard in
this opening. Keep
fingers out at all
times.
Figure 11: Safety Cover n closed position.
WARNING – Pinch Hazard
If the Safety Cover is closed and there is no product in the tool, there is risk of injury to any fingers inserted into the
openings that are normally occupied by the tubing and connector. The tool is not able to distinguish the absence of
BarbLock® components, so the jaws will move any time the Safety Cover is closed and the trigger is pressed. Keep
fingers away from all openings in the area of the jaws. Failure to do so could result in a serious pinching injury to
the fingers.
Jaws – each jaw pair is designed to fit specific BarbLock® part numbers. Refer to the reference list of jaw sizes at
the end of this document. Each jaw is marked with its part number. Jaws are to be used as a matched set, meaning
the same part number for the upper and lower jaws. There is an “A” suffix in the upper jaw part number and a “B”
suffix in the lower jaw part number. Mismatch of jaws is very likely to result in failure to close the BarbLock® and/or
damage to the BarbLock®.
Figure 12: Jaws
Push here for jaw
removal. Ensure that
air supply is discon-
nected during jaw
removal or installation.
