Sagola 30941001, Instruction Manual / Spare Parts List

Page: 20 / 48

KIT No. REFERENCE KIT NAME
17 300 900 87 Drain assembly
14 864 652 04 Complete suction probe
42 300 900 21 Non return valve
43 875 600 03 Suction valve
45 300 900 70 Upper block
47 300 900 22 Diaphragm
50 864 647 03 Regulator
48 857 700 99 Oil suction elbow
61 857 600 94 Petrol motor coupling
32 864 640 03 Petrol engine
54 864 100 68 Oil level
25 864 100 73 Antipulsation filter
300 900 99 Oil Renolin MR-10 (1 liter)
KIT No. REFERENCE KIT NAME
300 900 60 ROAD MARKING KIT
(includes road marking gun)
864 600 28 Road marking gun
91 300 100 13 Needle kit
(includes proportioning
head+seal)
- 20 -
6. USEFUL TIPS
- Use the lowest spray pressure in the air cap, allowing you
to obtain the required finish.
Not all products require the maximum pressure for correct
spraying. With lower pressure there is an additional increa-
se in product transfer.
- Pay special attention to the application speed. The
thickness of the film deposited may be greater than planned
if the application speed is low, and the opposite is also true.
- If the thickness of the layer is very thin, this is due to the
fact that the air pressure is excessive for the amount of
product being applied. Reduce the air pressure in the gun
in order to ensure that the thinner in the paint does not
evaporate during spraying and that it is not dry when it
reaches the surface to be painted. Increase the amount of
product, correct its viscosity or use a larger air cap in the
gun.
- If the film is very thick or granulated, this is due to the fact
that the amount of product to be applied is excessive for
the pressure used. Decrease the amount of product,
reduce its viscosity or use a smaller air cap in the gun.
- If sagging occurs, this is due to the fact that the amount of
product to be applied is excessive for the pressure used,
the viscosity is not correct or the application speed is not
adequate.
Decrease the amount of product, adjust its viscosity or
increase the application speed until the required finish is
obtained.
7. FUNCTIONAL DESCRIPTION OF THE EQUIPMENT
The equipments ATLANTA 800G y 800G Signaling can
be used to apply medium viscosity products used widely in
the Construction, Timber, Plastics Industry, etc.
The product to be applied (plastic paints, primers, varni-
shes, waterproof, fireproof, bituminous, epoxies, chlorina-
ted rubber for use in Signage, and all kinds of products of
low and medium viscosity) is kept in the container supplied
by the manufacturer.
From the manufacturer's container, with the unit in opera-
tion, by means of suction and through the probe it flows to
the interior of the unit.
From the unit, through the product hose and the gun, the
product is sprayed.
8. REPAIR AND MAINTENANCE KIT
SAGOLA S.A. has service Kits for the repair and replacement of consumable components in the unit, indicated in the explo-
ded view sheets.
Road marking kit