SAGEMCOM MF 4591, User Manual

Page: 17 / 92

Initial Operation · Connecting the Mains Cable 17
EN
Connecting the
Mains Cable
· Connecting the Mains Cable
Mains Voltage at the Site of Installation
1. Insert the mains cable into the connection locat-
ed on the rear side of the device. Plug the power
cable into the electrical outlet.
2. Switch the device on using the on/off switch on
the rear.
Spaltenumbruch
%%%Spaltenumbruch$$$
Initial Installation
· Initial Installation
Initial Installation
After you connect your device to the mains voltage,
the device starts. During the booting process, the
lights flash. Wait until the initial installation process
begins.
Selecting the Language
1. Use
[
to select the desired display language.
2. Confirm with
OK
.
Selecting the Country
Setting the Country Correctly
Setting the Country
1. Use
[
to select the country in which you are op-
erating the device.
2. Confirm with
OK
.
Set the Time Zone
Function is not supported in all countries and networks
(Function is not supported in all countries and net-
works)
Set the Time Zone
In countries with several time zones, you can select
from preset time zones or enter the deviance of your
time zone from UTC (see also chapter
Set the Time
Zone , page 59). In countries with one time zone, the
setting is adjusted automatically if you set the coun-
try correctly.
1. Use
[
to select the time zone in which you are
operating the device.
2. Confirm with
OK
.
Automatic Changeover Between Summer Time/Winter Time
Spaltenumbruch %%%Spaltenumbruch$$$
CAUTION!
Mains Voltage at the Site of Installation!
Check whether the mains voltage of your
device (indicated on the type label) matches
the mains voltage available at the setup lo-
cation.
CAUTION!
Setting the Country Correctly!
You must set the country in which you are
operating the device. Otherwise your device
is not adapted to the telephone network. If
your country is not included in the list, you
must select a different setting and use the
correct telephone cable for the country.
Consult your retailer.
Automatic Changeover Between Summer
Time/Winter Time
With setting the country and time zone, the
automatic changeover between summer and
winter time is switched on. The automatic
changeover is switched off if you enter the
deviance from UTC manually using the time
zones editor