Sagem WP 1130, Instructions For Use Manual

Page: 24 / 60

21
MENU
MENU
MENU
Factory default settings of the base station
The base station can be reset at any time to the default
settings when it left the factory.
The following list shows the original default settings of the
base station:
Function Setting
Dialling mode Tone
Priority for incoming calls All
Calls Barred 4x XXXX On
Press the MENU key several times until Telephone is
displayed.
Press the OK key to confirm.
Press the MENU key several times until Subscribe is
displayed.
Press the OK key to confirm.
Press the MENU key several times until Reset Bs is
displayed.
Press the OK key to confirm.
1- - - ? will then appear on the display.
Enter the number of the base station which you would like to
reset and then press the OK key.
BS Pin? will then be displayed.
Enter the pin of the base station (default 0000).
Press the OK key to confirm.
If the pin is correct, Reset? will be shown on the display.
If you have entered the incorrect pin, you will hear a warning
signal and Wrong Pin will appear on the display. After a few
seconds Subscribe will appear again.
Press the OK key.
Reset will be shown on the display.
If this procedure has been carried out without any errors, the
base station will confirm with an acoustic signal.
If the base station cannot be found, No Base will appear on
the display and shortly afterwards the Subscribe menu.
Press the Back key several times or wait 20 seconds until
the telephone switches back into the idle condition.