Appendix A - Troubleshooting
SAGEM F@st™ 1200/1240 User Guide - 252569421-01
Sagem Communication
document. Reproduction and disclosure prohibited
Page A-5
A.3.2
All LEDs off
¾
Check that the type of power supply available in your premises is in accordance with the
mains voltage needed to power your SAGEM F@st™ 1200/1240.
¾
Check that the power supply lead supplied is correctly connected at one end to the mains
power supply network.
¾
Check that the power supply connector is correctly inserted into the corresponding port
(Power) on the SAGEM F@st™ 1200/1240.
A.3.3
All LEDs blinking simultaneously
The modem/router has restarted in a "Recovery" degraded mode.
You
must
contact your
I
nternet
S
ervice
P
rovider (ISP).
A.4 Loss of modem/router IP address
If your modem/router's IP address is lost, communication by the configuration application with
the equipment becomes impossible.
When the configuration utility fails to set up
communication with the modem/router, the
window opposite appears.
You must enter the modem/router's IP
address then click
OK
to try to set up the
dialogue.
For the dialogue to be set up, the IP
addresses of your computer and your
modem/router need to be in the same
subnetwork plan.
If after a number of unsuccessful attempts the
Status
tab still indicates that the router is
unreachable, it will be necessary to restore your modem/router to its default IP configuration by
reverting to the factory configuration (see section A.5).
