11
Operating the Product
This section describes how to activate your fire using either the manual controls or remote control.
MANUAL CONTROLS
The manual controls are located beneath the fuel bed (Fig. 21).
M500
Mains Switch: Controls the electricity supply to the appliance. (Fig. 21A.)
Note: This switch must be in the
‘
O
N’(
I ) position for the appliance to operate.
Button Panel: Controls the functioning of the appliance. (Fig. 21B.)
•
is the on/standby button. Press it to turn on and off the flame effect. Turning it on will be indicated
by a single beep and the main LED lights activating. Be careful not to look directly into the LED
’
s as
they can be very bright. Although the main LED lights operate immediately, a further 45 seconds of
warm up time is required before the flame effect starts.
•
is the Pairing button. This will pair your remote control to the receiver. See
‘
Remote Control
Operation
’
for details.
•
is the test mode button. This will be used by the manufacturer and the Service Engineer.
•
is the reduce flame button. Press this to reduce the height/intensity of your flame. You will hear an
audible beep when you reach the minimum level.
•
is the increase flame button. Press this to increase the height/intensity of your flame. You will hear an
audible beep when you reach the maximum level.
•
is the reduce fire crackling sound. Press this to reduce the volume of the crackling sound. The
minimum volume for this is off. You will hear an audible beep when you reach the minimum level.
•
is the increase fire crackling sound. Press this to increase the volume of the crackling sound. You will
hear an audible beep when you reach the maximum level.
