MorphoWave
TM
OEM
– Installation guide
Section 3 :Installation Procedure
36
This document and the information therein are the property of Morpho.
They must not be copied or communicated to a third party without the prior written authorization of Morpho
2015_2000009096 V4
May 2017
Wiring overview
Before proceeding, make sure that the person in charge of installation and
connections is properly connected to earth, in order to prevent
Electrostatic Discharges (ESD).
In case of more than two digital signals use, digital grounds shall all be wired together
outside the product.
Figure 12: Ground wiring
Note that all connections of the MorphoWave™ OEM terminal described hereafter are
of SELV (Safety Electrical Low Voltage) type.
1
6
1
6
1
6
1
6
A
B
C
D
Door monitoring
system
Door status
GND 1
GPI1
Access
Control Panel
Wiegand interface
GND 2
7
1
6
1
6
1
6
1
6
A
B
C
D
Door monitoring
system
Door status
GPI1
Access
Control Panel
Wiegand interface
GND 2
7
Motion
sensor
GND 1
GPI0
