MorphoWave
TM
OEM
– Installation guide
Section 4 :First boot
64
This document and the information therein are the property of Morpho.
They must not be copied or communicated to a third party without the prior written authorization of Morpho
2015_2000009096 V4
May 2017
Configuring the terminal
MorphoWave
TM
OEM terminals are standalone biometric systems which offer
advanced features for access control. To guarantee biometric performances it is
required to load user’s templates acquired only with MorphoWave
TM
Desktop
biometric sensor.
MorphoWave
TM
OEM native mode
MorphoWave
TM
OEM terminal is by default in native mode that is named MA5G. It will
support the new features and configurations only in the native mode. The terminal can
be configured using an internet browser connected to the embedded Webserver
application.
Access Path
First Boot Assistant > Protocol Configuration > MA5G
Once the product is configured in native mode, the following methods can be used to
configure the terminal:
through the Ethernet interface (remote management)
Configuration procedures are described inside the MorphoAcces Sigma
©
Series
Administration Guide as follows:
Section 4: Terminal Configuration And Administration
