![background image](http://html1.mh-extra.com/html/safire/sf-vimod-cam-2/sf-vimod-cam-2_installation-manual_3394698011.webp)
Door Station Installation Guide
8
Chapter 3 Installation
Note
●
Make sure the device in the package is in good condition and all the assembly parts are
included.
●
Make sure the place for surface mounting is flat.
●
Make sure all the related equipment is power-off during the installation.
●
Tools that you need to prepare for installation:
Drill (ø6), cross screwdriver (PH1*150 mm), and gradienter.
3.1 Configure Sub Module Address
You need to set the sub module address via DIP before installation.
Steps
1. Remove the rubber cover on the sub module rear panel to expose the DIP switch.
Figure 3-1 DIP Switch
2. Set the sub module address according to the DIP rules, and install the rubber cover back.
Note
●
Digit 1, 2, 3, 4 are used to coding the sub module address; Digit 5, 6, 7 are reserved; Digit 8 is
a resistance (120Ω) is you set it as on.
●
Valid sub module address range is 1 to 8. The No. should be unique for sub modules that
connected to the same main unit.
The sub module address and corresponding switch status as below.