CCTV TESTER User Manual
20
6.4 PoE power / DC12V 3A power output
When the tester is turned on, the DC12V power output functions are automatically
turned on.
To use the PoE Power Output function,change the switch “ON” or “OFF”.
The IP camera needs to be connected to the LAN port before you turn PoE Power on.
If the IP camera Supports PoE, the PoE power is delivered via pins 1, 2, 3, and 6 on
the LAN port. The IP tester will display “48V ON” at the top of the screen when the
POE power is still on.
Note:
1. Don’t input power into the “DC12/3A OUTPUT” port.
2. Don’t output this DC12V/3A power to the DC12V/IN port of the IP camera tester to
avoid destroy.
3. The IPC tester power output i s close to 3A, if the IP camera’s power is over 3A, the
tester will auto enter protection mode. Disconnect all the connections of the tester and
then connect the tester with power adaptor to resume the tester.
4. Before turning on the PoE power output, please make sure the IP camera supports
PoE power. Otherwise it may damage the IP camera.
5. Make sure you plug in your IP camera to the LAN port prior to turning on PoE
power
6. Make sure the tester is full charged or more than 80% charged, otherwise the tester
will shows “low power”, “not able to supply power”.