SAFEMATIC ST-1100i, Manual, Page: 13 / 18

SAFEGREASE, SAFEOIL
ST-1100i
110i1CEN.doc 16.04.2003 Rev. 1C
11 (14)
4.3 Entering password
Select code PASS at time display.
Enter correct password using Settings/Pressure and arrow buttons.
When Settings/Pressure button is released, the center goes into Setting mode. The codes
show now decimal points, for example C.C.
Note Set value password is 2 .
4.4 Setting mode
Setting mode displays showing the lubrication program set values can be browsed by means of
arrow buttons.
Value display codes change in the following order when
Ï
-button is pressed and vice versa,
when
Ð
-button is pressed.
One can leave Setting mode but browsing to code PASS by means of
Ð
-button.
Display code Description
C.C.
Lubrication cycle counter
(
C ycle C ounter)
L.C.
Lubrication cycle set value
(
L ubrication C ycle)
L.P. Maximum pressurization set value
(
L ubrication, P ressurization time)
L.d. Lubrication delay time coefficient
(
L ubrication d elay)
Code is used only in pressure switch operation
L.o. Low limit pressure set value
(
Lo w limit pressure)
Code is used only in pressure transmitter operation
H.i. High limit pressure set value
(
Hi gh limit pressure)
Code is used only in pressure transmitter operation
4.4.1 Lubrication cycle counter
Code C.C . shows the lubrication cycle counter reading at display.
The counter can be reset by setting the counter value to zero using Settings/Pressure and
arrow buttons. The only changeable counter setting is to reset the counter.