24
© 2017 SafeLine and all the SafeLine products and accessories are copyrighted by law.
SETUP MENU
SYSTEM
EVAC v1.24 EN
Operating
To enter the menus, a “secret” key sequence is
needed.
The following keys need to be pressed in the
following order: “Left arrow, right arrow, enter,
enter”.
Then the “CONNECT PIN” access window appears.
To enter the “CONNECT” menu enter the correct
PIN.
To get to the setup menu:
• Press the “secret” key sequence.
• When the “CONNECT PIN” appears, press the
right functionkey (the highlighted key in the
illustration below) for 2 sec. until the “SETUP
PIN” access window appears.
• Enter the ADMIN PIN to get to setup menu.
ENTERING MENUS
All parameters in the EVAC system can be setup
in the entrance station’s “SETUP” menu.
All changes (apart from the real time clock)
are only made in RAM. Only when exiting the
setup menu and answering “YES” to saving the
settings, the parameters will be saved into the
unit.
To exit the “SETUP” menu, press and hold the
left functionkey.
There are two ways to connect to a unit. In
STANDBY mode it is possible to connect to a unit
by entering the connect menu. In EVAC mode it
is always possible to connect to the car, the floor
stations can only be connected to if an alarm has
been registered from the unit.
Connection can only be made between the
entrance station and a floor/car station.
By default the connected floor/car station will
have the microphone activated and will transmit
audio onto the audio bus. The entrance station
receives audio and the speaker is activated. If the
PTT input is activated on the entrance station,
the microphone will be activated and the speaker
inactivated. All other units’ speakers are then
activated and their microphones deactivated.
This means that the entrance station has priority
to speak at all times.
In the EVAC menu, the alarms received are
displayed with the current alarm floor name
displayed and the current number of queued
alarms. The number of queued alarms is updated
as new alarms are received.
The alarms are queued in the order they are
received. To connect to an alarm, move to the
alarm you want to connect to with the arrow
up/down, and press “ENTER” to connect. When
a connection to the alarm has been made, the
alarm will be removed from the queue.
It is always possible to connect to the car station
in the EVAC menu by pressing the left function
key.
In the “CONNECT” menu it is possible to connect
to the car station and all floor station registered
in the system. Please note that it is not possible
to connect nodes without a node ID or nodes
that have been inactivated in the setup menu on
the CAN-bus.
SETUP MENU
CONNECT TO A UNIT
EVAC MENU
CONNECT MENU
You can only enter the “SETUP”
and “CONNECT” menus when in
STANDBY mode.
The PIN-code is set to ”0000”
as the default value.
!
It is possible to change the default
language (English) to German.
Select: Setup Menu -> System ->
Languages -> Deutsch