SAFE HOME WS500S, User Manual

Page: 18 / 112

www.safehome.dk 18
D. Mounting with double sided tape
• Make sure the surface is clean.
• Take the film from one side of the tape and attach to unit.
• Take the film of the other side and fix the unit on the mounting surface.
E. Mounting using Screws
• Hold the enclosed mounting template against the wall at the selected location and
mark the points for drilling.
• Drill the holes and insert wall plugs.
• Attach the bracket to the mounting surface with the screws provided.
• Attach the Motion Sensor to the mounting bracket.
4.2.3 Enrolling the Remote Control onto the Smart Panel
The Remote Control devices can be enrolled (added onto the system) as follows.
Step Keys Description Note
1
PIN +
You must be in
STANDBY mode
before
programming To make sure you are in STANDBY
mode:
Enter your PIN
Press
, the symbol disap-
pears from the screen.
2
+
Press the buttons
on control panel to
enrol the remote
controls into the
system.
After pressing
any button on the
remote to regis-
ter and get an ID
number on remote
control. LCD display flashes the ID no. of
the remote to be enrolled e.g. when
enrolling the first remote ID no. “01”
will flash. Once the first remote is
enrolled the “02” will flash ready
for a second remote to be enrolled
(One beep indicates that the remote
was enrolled to the Smart Panel
successfully)
Note: It is recommended that the
ID No. is marked on the remote in
case it needs to be deleted at a later
stage
3 Complete the set-
ting After the setting is completed, return
the Smart Panel to STANDBY for
mode selection.