
INTEGRA/-S/-G/-GS User Manual INSTALLATION
SAF Tehnika JSC
24
Integra-GS 6-13GHz* remote mount kit assembly
Tools required
: Size 5 Allen wrench
13mm (0.512”) wrench (not supplied)
1
Assemble the mounting bracket using a 13mm
wrench:
Screw one hex flange nut [4] on each of the
four threaded rods [3]. Insert threaded rods into
available holes of the mounting clamp [1]. Put
hex nuts [4] on the other side of the clamp and
screw on the threaded rods until these are
visible from another side of the clamp, not
more than 2mm. Tighten hex flange nuts with
torsion 20...25 N·m.
Attach two mounting bracket clamps [2] on
threaded rods [3] as shown in the picture and
afterward screw on the remaining four hex
flange nuts [4] on all threaded rods.
2
Attach waveguide transition flange to the mounting
bracket using size 5 Allen wrench:
Put the flat side of the transition flange [5] on the flat
side of the mounting clamp [1] as shown in the picture
and screw in four socket head screws [6] from another
side of the clamp. Put two dowel pins [7] in the
appropriate holes of the transition flange. Pins are
sitting in holes very loose; therefore, perform the last
action immediately before FODU installation.
3
View of the assembled mounting bracket on
the thick pole mast:
Bracket clamps in the following position
support mast diameters of 55..120 mm.
4
View of the assembled mounting bracket on the thin
pole mast:
Bracket clamps in a reverse position support smaller
mast diameters of 25...75mm.
*Integra-GS 6U/6L/7/8/10/11/13 are separate FODU models
Summary of Contents for Integra
Page 1: ...SAF Tehnika JSC 1 User manual Integra Integra S Integra G Integra GS VER 2 37 FW 3 20 19...
Page 63: ...INTEGRA S G GS User Manual WEB GUI SAF Tehnika JSC 63 Status mode Press button...
Page 88: ...INTEGRA S G GS User Manual WEB GUI SAF Tehnika JSC 88 Status mode Press button...
Page 94: ...INTEGRA S G GS User Manual WEB GUI SAF Tehnika JSC 94 Status mode...