SAelen TS GS/TIGER 25D, Technical Manual

Page: 33 / 60

ADJUSTING THE TENSION OF THE ASSEMBLY CONVEYOR RUN
Note: do not tighten too much, a good grip of the feed roll and belt does not require excessive
tension. Use the maximum tension window (photo 4)
Maintenance and Service
Front roller
N.B.: Avoid feeding earth sodden root matter into
the machine. This may clog up the feed conveyor
slats and accumulate on the feed roller; thus the feed
roller diameter increases causing blockage.
3
Right tension
Too loose
In order to tighten the belt, you must loosen the
four nuts (A) at the side and tighten the tensioners (B) at the same time so the belt does not exceed the base
of the cell (see picture 1 ). Tighten the screws . (A) . Rotate the blet forward and backward a few times to check
its correct position.
1
2
3
After preparing the belt, check the tens-
tion for the first time after 4h and then at
regular intervals.
Maximum tension
window
4
1 2