SAelen TS GS/TIGER 25D, Technical Manual

Page: 28 / 60

MAINTENANCE INTERVALS MACHINE
Hours Interventions
Daily
-Control-tightening two nuts serrated articulation hitch
-Check operation of safety-punches and handrail red
-Check oil level engine
-Check fluid level radiator (DR)
Control-clean honeycomb radiator (DR)
Hitch-control vehicle / trailer (see p.17)
Check tightness of wheel-
Lighting-control
The first time after 4 am
-All fixing screws are to be checked for a tight fit
-Check the tension of the rotor transmission belts
-Check the tension of the metal belt
-Control tension belt oil pump (DR) (moderate tension) ( voir p.38 )
Every 10 hours
-Lubricate rotor hammers and verification wear rings
Every 50 hours
-Lubricate the two rotor bearings
-Check if the air inlet below the rotor is clean
-Check the blades and the hammers
-Check the tension of the rotor transmission belts and belt oil pump (DR)
-Lubricate the bearing of the feed roll
-Check the hydraulic oil level
-Check and remove the branches winding around the bearings' axes and the hy-
draulic motors
-Check the tension of the metal belt
Every 100 hours
- Replace rings hammers
Every 150 hours
-Lubricate the bearings of the F and B rolls of the metal belt
-Replace the hydraulic oil filter for the first time, then every 500 h (or 2 years)
-Check the counterblades for wear
Every 300 hours
-Check for wear of belt and gliding plate
-Check the electrolyte level in the battery
Every 500 hours
-Replace the hydraulic oil (or every 2 years)
-Replace the hydraulic filter of the return (or every 2 years)
-Replace the hydraulic oil suction filter in the tank
FREQUENCY OF MAINTENANCE ENGINE:
see the manufacturer's maintenance manual engine
Maintenance and Service