LUBRICATION POINTS
Lubricate and maintain the machine after the engine has been shut off and the ignition key removed
Maintenance and Service
LUBRICATE THE HAMMERS:
In order to gain access to the rotor:
-Remove the two Nylstop nuts
-Open the chute by rotating it on the articulation
-Clean the lubricating areas behind the hammer
with a small screwdriver or blowing device
-Lubricate the 20 hammers
Note: do not lubricate extensively,
~2 pumps per
lubrication point are enough.
Exaggerated lubrication could project excess
lubricant to the interior wall of the chute when the
rotor turns resulting in problems with transporting
chipped material.
LUBRICATING THE ROTOR BEARINGS
Summary of Contents for GS/TIGER 25D
