SAelen TS GS/TIGER 25D, Technical Manual

Page: 36 / 60

- Tighten the screws using Loctite with a 16b M/kg tightening torque and make sure the blades and inserts lean
against the wall
-Lubricate the axes of the hammers (pump ~2 x per hammer).
-Close the chute and the covers.
-Start the engine and warm it during a few minutes.
-Accelerate to maximum speed to make sure no abnormal vibrations disturb the functioning of the machine.
A tightening torque of the screws is essential to prevent their accidental unclamping
Maintenance and Service
- Control blades and hammer inserts
- Verification wear rings hammers
Inspections every 10 hours
Replace rings hammers all 100 h.