Saeco 711439308, Operating Instructions Manual

Page: 23 / 92

23
24
25
27
i
28
Installment
4 INSTALLMENT
To ensure your own safety and that of
others, carefully follow the “safety
rules” defined in Par.3.
4.1 Packaging
The original packaging has been designed
to protect the appliance during
transportation. You are recommended to
keep it for later use.
4.2 Installment requirements
Before installing the machine read the
following safety instructions carefully:
• Locate the machine in a safe place;
• Make sure that it is out of the reach of
children;
• Do not place the machine on a hot
surface or near a naked flame.
The machine is now ready to be connected
to the house electricity supply.
4.3 Electrical hook-up
Electricity can be dangerous,
so always follow the safety
regulations carefully.
Never use a faulty cable.
Faulty plugs and cables must
be changed immediately by authorised
personnel.
The coffee maker must be connected to a
suitable wall socket. The voltage of the
appliance has been factory-set. The voltage
on the rating plate (positioned on the bottom
of the appliance) must correspond to that
of your house electricity supply.
• Uncoil a length of cable from the cable
wind found underneath the appliance,
sufficient for the plug to reach the wall
socket.
• Check that the main switch is in the “0”
position before inserting the plug in the
wall socket.
• Plug the appliance into a wall socket
carrying the correct voltage.
4.4 Filling the water tank
• Remove the water tank lid (2).
• Lift out the water tank (1), making
sure you do not damage any of the tubes
inside it.
• Rinse and fill the tank with fresh water
without overfilling.
• Put the water tank back in its right
place, making sure that the tubes removed
previously are all immersed in water.
Warning! The tanks of some
models are equipped with a
water inflow valve. This valve closes
automatically when the tank is
removed to prevent water leakage.
When putting the tank back, press
lightly on it to open the valve.
• Put the lid back on the tank.
Always fill the tank with fresh,
not carbonised water: hot
water or other liquids may damage the
tank. Do not use the coffee maker
without water, always check that there
is enough water in the tank.
4.5 Priming
Before using the machine for the first time,
after the appliance has been left unused for a
long period or when the water and steam have
run out, it is necessary to prime the machine.
• Press the main switch (3); the light
indicator (11) will go on.
• Point the steam tube (“Pannarello”) over
the drip tray.
• Open the “hot water/steam” knob