14
SBK-BYOS2 INSTALL | 0419
Copyright ® 2019 S.R.Smith, LLC All rights reserved. |
srsmith.com
I N S TA L L AT I O N I N S T R U C T I O N S
B YO S 2 S L I D E
STEP 8: FINAL SLIDE POSITION - Continued
When checking for the correct flume angle keep the below in mind:
• Each slide section is identified on the underside.
• The exit section starts at 20° on the up slope end which then makes a gradual transition to 7˚ at the exit point.
• The entry section seating area is almost flat, however, for proper drainage it incorporates a slight downhill
slope which transitions to a full 20°. To ensure correct placement of the entry section the entry frame
support must be level to ensure correct orientation of the slide. (Fig. 19 & 20)
The sides of the flumes should be checked for level as well. The only place along the flume where level positions
can be determined is at the flange/gasket locations. Place level across the flume at the flume joint as illustrated.
(Fig. 21 & 22) Check each flange location for level position, adjust as necessary.
TIPS FOR SETTING THE SLIDE IN FINAL POSITION:
• It may take a series of adjustments to get the slide in its correct position.
• At this point the entire slide should be assembled, anchor supports attached and all bolts correctly tighten.
The slide should be blocked up in its approximate horizontal and vertical position.
(Continued on next page)
FIG. 19
FIG. 20
FIG. 21
FIG. 22
