7
SBK-BYOS2 INSTALL | 0419
Copyright ® 2019 S.R.Smith, LLC All rights reserved. |
srsmith.com
I N S TA L L AT I O N I N S T R U C T I O N S
B YO S 2 S L I D E
STEP 1: PREPARING SITE AREA FOR BYOS 2 SLIDE SYSTEM
First, Level the hill substrate to the approximate final grade.
TIP:
• The exit section should be supported at the fiberglass landing
plate. (Fig. 1) The exit plate can simply rest upon the substrate or
be drilled from the side and bolted to a bracket (not supplied).
NOTE: Build the support for the exit landing in the correct orientation
and at the correct height prior to setting the fully assembled slide
in place.
STEP 2: FLUME ASSEMBLY
Starting with the exit section, assemble the slide on the ground, right
side up along actual pathway where the slide will reside. (Be careful not
to scratch the slide) Attach the exit section anchor support, followed by
the next flume section in the correct order of the slide pathway. To help
identify the flume sections for the correct order of assembly, there are
stickers attached at each flange end of each flume section. For example,
attach the letter A end of the exit section to the letter A end of the
next flume section of your custom BYOS slide. (Fig. 2 - sample only)
Attach the anchor supports in the specified locations as you build uphill
and away from the pool. Stickers are attached to the side of the flange
connection that the anchor support will connect to.
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1. 3/8” Drive Ratchet
2. 3/8” x 6” Socket Extension
3. 9/16” Socket
4. 9/16” Box End Ratchet Wrench
5. Torque Wrench
6. Angle Finder
7. Tape Measure
8. 48” Level
LIST OF REQUIRED TOOLS
Tools required for assembly and installation of BYOS 2 slide:
NOTE:
Anchor support locations are noted on a separate sheet (included) that is specific to your exact slide design.
There are stickers attached to the correct flume piece to indicate which side of the flange you need to connect the
anchor support to.
FIG. 2
F’S
E’S
D’S
C’S
B’S
A’S
EXIT SECTION LANDING PLATE
FIG. 1
