S-Access SA-4W-REPEATER, User Manual

Page: 17 / 26

SA-4W-REPEATER
User Manual
S-Access GmbH
Tel: +41 44 700 31 11
Oberhausenstrasse 47
Page
17
of
26
Fax: +41 44 700 31 03
8907 Wettswil a/A Email: contact@s-access.ch
Switzerland WEB: www.s-access.ch
Definitions:
LOS/LFA-H: Loss of signal or frame alignment at xDSL loop
SEGD: Segment Defect indication
BER-H:
xDSL block-error-rate according G.826
≥
30%
LOOP2: xDSL test loop 2 active
8.3.4.4 RESET Command
By typing RESET, the system unit will be restarted.
CO_01_FMM> RESET
system reset
8.3.5 Configuration management CM
Configuration management activated
Enter <M> to return to MAIN, or <H> for HELP information
Type <
H
> and the monitor lists all available commands in the configuration sub-menu.
8.3.5.1 General note
If the repeater works in 4 wire mode the commands ANNEX, BASERATE, RATEADAPTION
in some modes the user has to enter 2 parameters.
Example:
Annex A,B
8.3.5.2 CONFIG Command
The CONFIG command displays the configuration of the unit.
8.3.5.3 MODE Command
This command sets the operation mode.
Parameters: S
→ Normal mode
D → Dual pair mode
8.3.5.4 ANNEX Command
This command sets the Annex to the desired mode.
Parameters: A
→ Annex A
B → Annex B
AUTO → Auto selection
8.3.5.5 ID Command
This command sets a unique identification string printed on the main screen.