SA-4W-REPEATER
User Manual
S-Access GmbH
Tel: +41 44 700 31 11
Oberhausenstrasse 47
Page
11
of
26
Fax: +41 44 700 31 03
8907 Wettswil a/A
Email:
Switzerland
WEB:
www.s-access.ch
8 MONITOR
8.1 General
The module can be connected to a terminal or a PC (with terminal emulation) in order to monitor
relevant events and to display additional information such as the signal quality of the xDSL link or
the G.826 error performance parameters. In addition, full system configuration and fault
localization can be done over the monitor interface
The terminal for monitoring should be VT100 compatible and configured as follows:
•
9600
baud,
asynchronous
•
8 bits, no parity, one stop bit
•
no new line on carriage return (i.e. no line feed on carriage return)
•
flow
control
none
8.2
Structure & Organization
The structure and organization of the S-Access monitor is adapted to ITU-T Recommendation
M.3400 for TMNs with its five sub-sets.
Sub-set Short-form
Performance management
PM
Fault and maintenance management
FMM
Configuration management
CM
Accounting management
AM
Security management
SM
A S-Access does neither support Accounting management nor Security management. AM and SM
are not in the monitor's main menu.
At any time, the <H> (“Help”) command shows and explains the available commands and their
parameters.
For details or a more precise explanation of a command type: H
´command´
The prompt on the screen consists of:
•
a repeater indication (RR_)
•
the repeater address indication
•
the short form of the specified sub-set menu.
“RR_04_FMM>”.
Note: Repeater address is calculated as repeater position (starting from CO side) in the xDSL
chain plus 2. Thus the repeater nearest to CO side has address 03, second one – 04, etc.