7 - English
DANGER:
Do not use oxygen, combustible gases or bottled gases
as a power source for this tool. The tool will explode and
cause death or serious injury.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict severe injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1 along with hearing and head
protection. Failure to do so could result in objects being
thrown into your eyes and other possible serious injuries.
WARNING:
Disconnect the tool from the air supply and remove nails
from the tool before leaving the work area, moving the
tool to another location, or handing the tool to another
person. Failure to do so could result in serious personal
injury.
APPLICATIONS
You may use this tool for the purposes listed below:
Finish and Trim (interior and exterior)
Decorative Trim
Book Cases
Baseboard
Cabinets
Case Backs
Drawers
Molding
Mirror and Picture Frames
Paneling
Shoe & Base Moldings
Staircases
Upholstery Trim Panels
Wainscoting
Window Beading
Chair Rail
Furniture Frames
Lattice Strip Molding
Nailable Plastic Parts
Crafts
OPERATION
WARNING:
Always wear eye protection. Eye protection does not fit all
operators in the same way. Make sure the eye protection
chosen has side shields or provides protection from flying
debris both from the front and sides.
PREPARING THE TOOL FOR USE
See Figure 1, page 12.
Under normal use conditions, the tool should be lubricated
before connecting the tool to an air supply. Add air tool
lubricant into the air fitting on the tool once daily with minimal
use, or twice a day with heavy use. Only a few drops of oil
at a time is necessary. Too much oil will only collect inside
the tool and will be noticeable in the exhaust cycle.
Before connecting the tool, check the air compressor gauge to
be sure it is functioning within the proper range of 70-120 psi.
ADJUSTING THE EXHAUST
See Figure 2, page 12.
The adjustable exhaust on the top cap of the tool allows the
operator to direct the exhaust according to preference. To
adjust, turn the exhaust cap until the exhaust blows in the
desired direction.
WARNING:
Disconnect the tool from the air supply and remove nails
from the tool before leaving the work area, moving the
tool to another location, or handing the tool to another
person. Failure to do so could result in serious personal
injury.
CONNECTING THE TOOL TO AN AIR SUPPLY
See Figure 3, page 12.
DANGER:
Do not use oxygen, combustible gases or bottled gases
as a power source for this tool. The tool will explode and
cause death or serious injury.
WARNING:
Disconnect the tool from the air supply and remove nails
from the tool before leaving the work area, moving the
tool to another location, or handing the tool to another
person. Failure to do so could result in serious personal
injury.
This tool is designed to operate on clean, dry compressed air
at regulated pressures between 70 and 120 psi . The correct
air pressure is the lowest pressure that will do the job.
NOTE:
Air pressure that is higher than 120 psi may damage
the tool.
Summary of Contents for YG200BN2
Page 34: ...14 NOTES NOTAS...
Page 35: ...15 NOTES NOTAS...