13
WARNING:
When servicing, use only iden ti cal replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the tool when cleaning or performing
any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at an Authorized Service Center.
Remove all batteries from the power tool if you will not
be using the power tool for an extended time.
CHANGING THE BATTERIES
The remote control, stick driver, and AIRgrip system are
each powered by a standard 9V battery. When the battery
in the AIRgrip system is low, the power light will change
from green to red. Change the battery immediately.
To change the battery in the remote control, stick
driver, or AIRgrip system:
Remove the battery cover from the unit.
Remove the battery and replace with new 9V battery.
Replace the battery cover.
MAINTENANCE
Fig. 12
STORAGE
See Figures 12 - 13.
A storage rack with a “key hole” hanging feature is provided
for convenient storage of the fully assembled EZ Reach
system. Screws and wall anchors should be installed so that
the center distance is 3 in.
NOTE:
Store fully assembled EZ Reach only as instructed.
Storing EZ Reach system:
Snap fully assembled EZ Reach into storage rack between
AIRgrip system and stick driver.
Storing suction heads:
Align groove of suction head with side groove of storage
rack and slide into place.
Storing extension pole:
Remove EZ Reach system from extension pole.
Hang pole using hanger cap located at the end of pole.
NOTE:
Store extension pole separately from assembled
EZ Reach system when using hanger cap.
Fig. 13
OUT
IN
GRIP
/RE
L
HANGER CAP
STORAGE RACK
SUCTION
HEAD
STICK DRIVER
AIRGRIP™
SYSTEM
