10
ATTACHING/REMOVING SUCTION HEAD
See Figures 5 - 6.
Two suction head attachments have been provided with the
EZ Reach. Use the small suction head to change smaller
sized light bulbs such as R20, PAR 20, R16, PAR 16, and A19
bulbs. Use the large suction head to change larger sized light
bulbs such as R40, PAR 38-40, R30, and PAR 40 bulbs.
NOTE: Do Not
use EZ Reach on light bulbs with exposed
textured surfaces.
NOTE:
Before initial use, wipe the AIRgrip seal with a damp
cloth to remove any residue.
To attach suction head:
Choose appropriate sized suction head for the bulb.
Align groove in AIRgrip system with groove in bottom of
suction head.
Snap suction head into place.
To remove suction head:
Depress attachment release lock on AIRgrip system.
Remove suction head.
Release attachment release lock.
REMOTE CONTROL
See Figure 7.
The remote control is used to activate the AIRgrip system
and stick driver. Use the hook-and-loop pad to attach the
remote control to the extension pole or stick driver.
NOTE:
The remote control buttons should face the
operator.
To attach the hook-and-loop pad to extension pole:
Wipe pole with a clean cloth to remove any residue.
Grip extension pole in a comfortable operational
position.
Remove backing from hook-and-loop pad and stick pad
in position just above where you are gripping the pole.
NOTE:
The hook-and-loop pad should be placed on the pole
in such a way to allow comfortable operation of the remote
control buttons when remote is attached to pad.
Apply firm and even pressure to the pad, making sure no
air bubbles form underneath and the pad fully adheres to
the pole.
OUT
IN
GRIP/R
EL
Fig. 5
Fig. 6
Fig. 7
SMALL SUCTION HEAD
HOOK-AND-LOOP PAD
GROOVE
ATTACHMENT RELEASE LOCK
LARGE SUCTION HEAD
GROOVE
EXTENSION POLE
REMOTE CONTROL
ASSEMBLY
R-20
PAR-20
A-19
R-16
PAR-16
R-40
PAR 38-40
R-30
PAR-40
