Rush MH 2 Wash, User Manual

Page: 18 / 40

18
RUSH MH 2 Wash user manual
Show Mode (stand-alone operation)
The fixture will enter Show Mode and run stand-alone operation:
•
if the fixture is not receiving a DMX signal and you select SHOW MODE in the
control panel, or
•
if the fixture is not receiving a DMX signal and BLACKOUT is set to NO in the
control panel (see ‘Blackout’ on page 21), or
•
if you send a command on the fixture settings DMX channel to set the fixture
to stand-alone operation.
Four pre-programmed stand-alone shows are available. To set the show that
the fixture will run in Show Mode:
1. Select SHOW MODE and press ENTER to confirm. The currently selected
show will blink in the display.
2. Use the DOWN and UP buttons to select Show 1, Show 2, Show 3 or
Show 4.
3. Press ENTER to save your selection (or press MENU to exit without
saving any changes).
Sound activation in Show Mode
Show Mode can be combined with sound activation. The fixture has a built-in
microphone that can be used to trigger scene changes in sync with a music
beat (music trig) when the fixture is running in Show Mode.
To enable sound activation:
1. Select SOUND STATE and press ENTER to confirm. The currently set
mode will blink in the display.
2. Use the DOWN and UP buttons to select ON (sound activation enabled) or
OFF (sound activation disabled).
3. Press ENTER to save your selection (or press MENU to exit without
saving any changes).
To adjust the sensitivity of the sound activation microphone to match the
volume of the music beat:
1. Select SOUND SENSE and press ENTER to confirm. The currently set
sensitivity level will blink in the display.
2. Use the DOWN and UP buttons to change the sensitivity level from
0 …100.
3. Press ENTER to save your selection (or press MENU to exit without
saving any changes).