RUSH DC1 Aqua User Manual
10
Introduction
The RUSH DC 1 Aqua™ is a dynamic effect lamp that projects moving water
effects. It has a 75 W LED engine with long-life white LEDs. Besides fully
adjustable water effect projections, the DC 1 Aqua features a color wheel with
five color flags and smooth 0-100% continuous electronic dimming. The fixture
is rugged, lightweight and compact.
The DC 1 Aqua can be controlled using any DMX-compliant controller or it can
run in standalone mode with a choice of three shows. Fixtures in standalone
mode can be linked and their shows synchronized in master/slave operation.
The fixture is supplied with this user manual, a 1.5 m (5 ft.) power cable (local
power plug not included) and a folding bracket that can also be used for
rigging clamp attachment.
Before using the product
1. Read ‘Safety information’ on page 5 before installing, operating or
servicing the fixture.
2. Unpack and ensure that there is no transportation damage before using
the fixture. Do not attempt to operate a damaged fixture.
3. If the fixture is not going to be hard-wired to a mains supply, install as
directed in this manual a local power plug (not supplied) on the supplied
power cable.
4. Before operating, ensure that the voltage and frequency of the power
supply match the power requirements of the fixture.
5. Check the RUSH support pages on the Martin Professional website at
www.martin.com for the most recent user documentation and technical
information about the fixture. RUSH by Martin™ user manual revisions are
identified by the revision letter at the bottom of the inside cover.
Note that when the fixture is powered on for the first time, it may smoke slightly
as it warms up, but this will only last a few minutes and is no cause for
concern.
