RUSH DC1 Aqua User Manual
20
When fixtures are correctly connected and set up in master/slave operation,
the Master status LED on the master fixture and the Slave status LED on slave
fixtures light constantly.
Recovering from Loss of Step in Master/Slave Operation
If you power a master fixture or a slave fixture off while a chain of fixtures is
operating in master/slave mode, master/slave synchronization will be lost.
There are three possible ways of recovering from this and getting fixtures to
run the master/slave show in sync again. You can use one of the following
methods:
•
Power all fixtures off then on again.
•
Activate the master fixture's menu mode by entering the menus in the
master fixture's control panel. Then, after a few seconds, exit the menus.
•
Send a DMX signal to all fixtures. Then, after a few seconds, shut down
the DMX signal.
Backlight
To turn the control panel display backlight on or off:
1. Select BACK LIGHT menu and press ENTER to confirm. The present
mode will blink in the display.
2. Use the DOWN and UP buttons to select ON or OFF.
3. Press ENTER to save your selection (or press MENU to exit without
saving any changes).
Manual Mode / manual standalone control
Fixture functions can be tested and controlled manually. To manually control
effects:
1. Select MANUAL MODE and press ENTER.
2. Use the DOWN and UP buttons to select COLOR, WAVE 1, WAVE 2 or
DIMMER. Press ENTER to select (or press MENU to exit without making a
change).
3. Use the DOWN and UP buttons to specify a value from 0 to 255 for the
selected effect.
4. Press ENTER to confirm the value and activate the effect (or press MENU
to exit without making a change).
5. Each time you confirm a selection with ENTER, press MENU to go back
through the menu structure.
