Runco LIGHTSTYLE LS-HB, Installation & Operation Manual, Page: 89 / 112

Maintenance and Troubleshooting
Runco LS-HB/LS-HB Ultra Installation/Operation Manual 73
PRE
L
IMINAR
Y
5.1
Lamp Replacement The lamp should be replaced when it reaches the end of its life (typically 2000 hours), or
sooner if a noticeable degradation in brightness occurs. Contact your Runco dealer to
obtain a replacement lamp.
1. Turn off the projector and unplug the power cord. Allow the projector to cool
down for approximately 60 minute s prior to removing the lamp a ss embly for
replacement.
2. Using a flat-blade screwdriver, loosen
the two screws holding the rear
compartment cover in place.
3. Remove the rear compartment cover
by tilting it upward.
4. Loosen the screw on the lamp cover
and pull the lamp cover out.
5. Loosen the two screws on the lamp
module.
6. Pull the lamp module handle firmly to
remove the lamp module.
7. Perform Steps 6 through 2 (in reverse
order) to install the new lamp module.
8. Turn on the power and reset the lamp
timer.
5. Maintenance and Trouble s hooting