Runco LIGHTSTYLE LS-HB, Installation & Operation Manual, Page: 83 / 112

Operation
Runco LS-HB/LS-HB Ultra Installation/Operation Manual 67
PRE
L
IMINAR
Y
Figure 4-14. PIP S plit- S creen Mode
Menu Po s ition: Select Menu Position from the System menu to change the OSD menu
position. The default setting is “ “ (top left).
Tran s lucent Menu: Select Translucent Menu from the System menu to adjust the
degree of translucence (show-through) in the menus and message boxes. 0% means that
the menus are opaque. The default setting is 25%.
Blank S creen: Select Blank Screen from the System menu to choose the color of the
blank screen that appears when no source signal is present. The options are Black , Blue
and White . The default is Black .
Auto Power Off: Set Auto Power Off to On to have the LS-HB turn itself off after 20
minutes of inactivity (no source signal present).
Auto Power On: Setting Auto Power On to On causes the projector to automatically
power up when AC power is present. If the projector is plugged into a switched AC outlet,
this allows the projector to be turned on using a wall switch instead of the remote control
unit. If you do not need this capability, set Auto Power On to
Off (this is the default
setting).
Rear Projection: This control reverses all images and menus, and is necessary when the
projector is used in rear-projection applications. The default is Off .
Ceiling Mode: This control flips the image so the projector can be used in ceiling
mounted installations. The default setting, Auto , automatically determines the orientation
using an internal sensor.
Power On Chime: This controls the audible chime at startup.