Runco LIGHTSTYLE LS-HB, Installation & Operation Manual, Page: 38 / 112

Installation
22 Runco LS-HB/LS-HB Ultra Installation/Operation Manual
PRE
L
IMINAR
Y
Installing the Lens 5. Carefully remove the lens and other installation hardware (in a small plastic bag) from
the shipping container.
6. Remove the rear cap from the lens. This protective cap is only used during shipping to
protect the lens from damage.
7. Remove the front cap from the lens.
8. Install the spring clip (provided with the lens) on the lens shift adjuster retaining slot, as
shown. The clip reduces backlash in the vertical offset mechanism to keep it from
inadvertently moving after adjustment.
9. Insert the lens into the lens cavity. Ensure that the notch on the vertical lens shift
adjuster mates with the retaining slot on the projector, as shown below. Otherwise,
the adjuster won’t work correctly.
10. Install the two (2), black plastic retaining clips (also provided with the lens) on either
side of the lens cavity. Each clip is held in place with two (2), captive Phillips screws.
The white, plastic standoffs serve as “handles” to make removing the clips easier.
➤