Cutting Centre SR 2 BiTurbo
6
!!! To shut down the machine the main switch must be turned to
“0”
-
OFF" and the power plug pulled from the outlet! Secure the machine
against further use!
!!! The supervisor must arrange for the repair of the non-functional
safety device by a Rühle service engineer. Until the corresponding
parts have been repaired, the supervisor must ensure that the ma-
chine or parts of the machine are not put into operation under any cir-
cumstances!
This applies also to leaking hydraulic systems!
!!! The cleaning personnel must observe the work procedures from the
“Cleaning”
work instructions prepared by the supervisor.
!!! The maintenance personnel may only carry out work specified as
“regular care”
, unless any other authorisation has been issued in writ-
ing by the manufacturer of the machine. The maintenance personnel
must observe the work procedures from the
“Maintenance”
work in-
structions prepared by the supervisor.
Disconnect the power plug for maintenance work!
!!! Do not modify the machine.
!!! Only use Rühle spare parts and accessories.
!!! The operating instructions as well as all other technical documents
included must be supplied completely when reselling the machine.
1.2
Remaining risk of accidents
!!! All life cycles phases
Damaged knife elements must be replaced!
Cut protection gloves must be worn when working:
•
on the open knife protection box,
•
on the cut-off knife,
•
on the grate knives of the knife levels,
