Cutting Centre SR 2 BiTurbo
18
d)
Check the slider (funnel closure) and its guide pins for dam-
ages and abrasion; remove sharp edges!
e)
Check the guide rails of the slider (funnel closure) in the ma-
chine and the grate frame; remove sharp edges!
f)
Check the rollers of the eccentric shafts (drive shaft for the
knife level) and of all grate frames:
a.
For easy running and axial play!
b.
For abrasion (plane surfaces)!
Replace defective rollers!
In case of abrasion, check the corresponding sliding sur-
face on all knife levels for damages!
Replace defective knife levels!
g)
Visually check for changes or damages on all machine sides
and accessible machine parts, e.g. the knife levels. The ma-
chine must be shut down in the event of any damage or
changes!
h)
Visual inspection for hydraulic oil loss under the machine.
5.2
Regular maintenance
Regular maintenance of the machine must be carried out every 2000
hours of operation but at least once per year.
Maintenance schedule:
a)
Inspect the safety devices as described in chapter 1.1
“Safety
instructions”
!
b)
Carry out a test run with open machine (caution: moving
parts)!
c)
All inspection activities and resharpening tasks specified un-
der
“Regular Care”
!
d)
Change the oil of the hydraulic system! For filling, see 7.1
Technical data.
e)
Leak test of the hydraulic system!
f)
Check hydraulic hoses for damages or cracks! Defective hy-
draulic hoses must be replaced!
