4. Verify the configuration.
device(config-if-e40000-1/1/1)# show running-config interface | begin broadcast
broadcast limit 96 kbps
multicast limit 400 kbps
unknown-unicast limit 96 kbps
...
Rate limiting BUM traffic configuration example
device# configure terminal
device(config)# interface ethernet 1/1/1
device(config-if-e40000-1/1/1)# broadcast limit 96 kbps
device(config-if-e40000-1/1/1)# unknown-unicast limit 96 kbps
device(config-if-e40000-1/1/1)# multicast limit 400
device(config-if-e40000-1/1/1)# show running-config interface | begin broadcast
Configuring ACL-based fixed rate limiting using traffic policies
Use the procedure in this section to configure ACL-based fixed rate limiting. Before configuring this feature, see what to consider in the
“Configuration notes and feature limitations for traffic policies” section.
These commands:
•
Set the maximum number of traffic policies.
•
Create a fixed traffic policy that enables ACL statistics (counting).
•
Create a new extended ACL entry and binds the ACL to an interface.
•
Verify the configuration.
1. Enter global configuration mode.
device# configure terminal
2. Set the maximum number of traffic policies supported on a device.
a)
Set the maximum number.
device(config)# system-max hw-traffic-conditioner 25
b)
Save the configuration.
device(config)# write memory
c)
Reload the software to place the change into effect.
device(config)# reload
Ruckus does not recommend setting the system maximum for traffic policies to 0 (zero), because this renders traffic policies
ineffective.
Rate Limiting and Rate Shaping
Rate Limiting
Ruckus FastIron QoS and Traffic Management Configuration Guide, 08.0.70
Part Number: 53-1005294-01
57
