After the egress-buffer share port level is defined, it can be associated with one or more ports.
Perform the following steps to configure the egress-buffer share port level.
1. Enter global configuration mode.
device# configure terminal
2. Configure the share level.
device(config)# qos egress-buffer-profile egress2 port-share-level level3-1/16
In this step, the egress2 buffer profile is configured with a queue share level 3 for a maximum 1/16 portion of the total buffer
memory that can be used in a sharing pool.
3. Access interface mode for the port to which you want to apply the profile.
device(config)# interface ethernet 2/1/4
4. Attach the profile to the port.
device(config-if-e10000-2/1/4)# egress-buffer-profile egress2
5. Return to privileged EXEC mode.
device(config)# Ctrl-z
6. Verify the configuration
device# show qos egress-buffer-profile egress2
Egress Buffer Profile: egress2
Ports attached: 2/1/4
Port share level: level3-1/16
7. Save the configuration.
device# write memory
Share port level for an egress buffer profile configuration example
device# configure terminal
device(config)# qos egress-buffer-profile egress2 port-share-level level3-1/16
device(config)# interface ethernet 2/1/4
device(config-if-e10000-2/1/4)# egress-buffer-profile egress2
device(config)# Ctrl-z
device# show qos egress-buffer-profile egress2
device# write memory
Configuring a port to the egress queue drop counters
On the Ruckus ICX 7250, ICX 7450, and ICX 7750 devices, each port has its own set of drop counters. However, the Ruckus ICX 7150 has
only one set of egress queue drop counters and can monitor only one port for the incrementing of the counters. By default, the device
monitors the local CPU port for control packet drops. However, you can configure the device to monitor a different port for packet drops.
NOTE
This configuration is supported only on the Ruckus ICX 7150.
Quality of Service
Configuring QoS
Ruckus FastIron QoS and Traffic Management Configuration Guide, 08.0.70
48
Part Number: 53-1005294-01
